Leader
Pin Bushings
 These
precision machined leader pin bushings are
specifically designed to be used with
Stahl leader pins. Made from high grade
meehanite iron, they will provide fast and
accurate alignment between the two mold
halves. With the use of a retaining nut
and specially designed shoulder they can
be easily replaced as mold wear dictates,
there-by providing consistent alignment
throughout the life of a mold.
With
internal diameters from .500" to
1.000" these bushings can be used in
the construction of both small and large
permanent molds. Each bushing comes with
one jam nut.
 Please
refer to the Typical Permanent Mold
Assembly sheet and individual catalogue
sheets fro all your mold component
requirements.
|
